The total cost of owning an appliance is its purchase price plus what it costs to run, service and repair over its life, divided by the years you use it. Here is the sum for one made-up fridge over ten years, built from entries you can pull out of your own tracker. All the figures are invented to show the method, so replace them with yours.
What costs belong in the total?
- Purchase price, including delivery and installation if you paid for them.
- Electricity used over the years, as an estimate.
- Paid service visits and any AMC you bought.
- Repairs after the warranty ended.
- Disposal cost or resale value at the end, if there is one.
How do you estimate the electricity share?
A bill covers the whole house, so the appliance's share has to be estimated. Take the average watts the appliance draws, multiply by hours used per day, divide by 1,000 to get units per day, multiply by 30 for a month, and then by the per-unit rate on your own electricity bill. A fridge runs all day but its compressor cycles on and off, so label this figure an estimate. Suppose, with made-up numbers, an average of 50 watts over 24 hours: 50 × 24 ÷ 1,000 = 1.2 units a day. Times 30 is 36 units a month. At a made-up ₹7 a unit, that is ₹252 a month and ₹3,024 a year.
What does the ten-year sum look like?
| Cost line | Made-up basis | Amount |
|---|---|---|
| Purchase price | Paid at the shop | ₹32,000 |
| Electricity share | ₹3,024 a year × 10 | ₹30,240 |
| Paid service visits | 3 visits at ₹500 | ₹1,500 |
| One repair after warranty | Year 7 | ₹4,500 |
| Total over ten years | 32,000 + 30,240 + 1,500 + 4,500 | ₹68,240 |
| Cost per year | ₹68,240 ÷ 10 | ₹6,824 |
Notice what the table shows: in this made-up case, electricity is a little less than the purchase price, and the repair is a small part of the total. In another household, with different use and tariffs, the balance would differ.
Where do the numbers come from?
Purchase price comes from the bill. Service and repair amounts come from the job sheets and receipts, which is why a claim log and a bill folder pay off twice. Electricity is the only estimated number, so keep the workings in a notes cell. If you use SpendixAI, repair and service payments you add by hand or import from a statement can be pulled up by category or merchant, and the receipts stay with each entry.
How can you use the per-year number?
When the appliance starts needing repairs, compare what a repair costs with the per-year cost of owning it. A large repair on an old appliance is not automatically a reason to replace it, and a new purchase is not automatically cheaper. The sheet only puts the numbers side by side; the decision is yours, and a technician's honest opinion on remaining life also matters.
What if you resell or give it away?
Subtract any amount you receive from the total, and divide by the number of years you actually had it. If you paid someone to take it away, add that. Keep the arithmetic visible, so the next purchase can use it.
What if you use the appliance differently from the example?
Change the electricity workings to match your own use. A second fridge that runs part of the year, an air conditioner used for a few months, or a geyser used twice a day will give very different totals. Write the months of use per year in the workings cell so the estimate stays honest, and you can reuse the same sheet for any appliance by changing the watts and the hours.
A sheet to copy
- One row per cost, with date, type and amount.
- A total at the bottom with SUM and a per-year line.
- A separate cell for the electricity workings.
- A note of the years in service.
Useful ideas start with a clearer picture of your own spending.
Explore your reports


