The price on the invoice is not the price in the product
A supplier sells a material by weight, length or sheet. The product uses only part of it, because some is trimmed, cut away, lost in processing, or rejected for defects. Costing a product at the invoice price per unit therefore understates the real cost, sometimes by a lot.
The cost that matters is the price per usable unit: what it costs to get one unit of the material into the finished product.
The yield calculation
Yield is the share of purchased material that ends up usable. To find it, weigh or count the material bought, then measure what remains after trimming, cutting and rejects.
Suppose 100 kg of a material is bought for 12,000 units, which is 120 per kilogram. After processing, only 82 kg is usable. The cost per usable kilogram is 12,000 / 82, about 146.
That is a gap of 26 per kilogram, more than a fifth above the invoice rate. A product priced from the 120 figure is underpriced from the start.
Compare suppliers on usable cost
Two suppliers may quote different rates for what looks like the same material, yet yield differs. A cheaper, rougher grade can lose more in processing.
| Supplier | Price per kg | Yield | Cost per usable kg |
|---|---|---|---|
| --- | --- | --- | --- |
| A | 120 | 82 percent | about 146 |
| B | 132 | 94 percent | about 140 |
Supplier B costs more per kilogram but less per usable kilogram. Without the yield, the choice would have gone the wrong way.
How to measure without a laboratory
A rough measurement is fine. Take one or two typical batches, weigh before and after, and note the result. Repeat a few times across the season, since quality varies. An average yield from five batches is far better than a guess.
Record the results next to the supplier’s name, so that a pattern appears when quality changes. A sudden drop in yield is a useful early warning about a supplier or a storage problem.
Reducing the loss
Once the loss is visible, there are choices. Ask the supplier for a better grade, a pre-trimmed form or a different pack size. Adjust cutting patterns to use offcuts. Find a second use for trimmings, such as smaller products or sale as a by-product. Even a modest improvement in yield repeats on every batch.
Put it into the product cost
Use the cost per usable unit in all pricing and margin work. Update it whenever the supplier, grade or process changes. Keep a short table of the main materials, their invoice price, yield and usable cost so that quotes can be built quickly and accurately.
Tracking in the app
In SpendixAI, record each raw-material purchase with a note of weight or quantity. At the month-end review, compare the amount bought with the amount used in finished goods. A growing gap points to loss, theft or recording errors, and is a prompt to check the yield again before prices slip below cost.
Keeping the yield figure fresh
Yield changes with season, supplier batch and even the person doing the cutting. A figure measured once a year is soon out of date. Re-measure whenever a new supplier is tried, whenever a complaint about quality arises, and at least twice a year for the main materials.
Pin the latest yield beside the price list where quotes are prepared. When the figure is visible at the moment of pricing, it gets used, and the gap between invoice cost and real cost stops being a surprise at month-end.
Storage and spoilage
Part of the loss between invoice and plate is spoilage rather than trimming. Keep stock in the conditions it needs, label deliveries with dates and use older stock first. Check that cold storage holds its temperature, since a failing unit can destroy a week’s purchases overnight. A weekly look at items close to their end date lets them be used, discounted or processed before they become a total loss.
Useful ideas start with a clearer picture of your own spending.
Explore your reports


