Shopping

Split or window AC: compare running cost using your own power bill

Split AC vs window AC electricity cost: a method using your own summer power bills, hours of use and a worked table of made-up units and rates.

Editorial illustration for Split or window AC: compare running cost using your own power bill

To compare a split and a window AC on running cost, work out how many extra units your summer bill shows, estimate hours of use, and multiply the units for each AC by the rate on your bill. All numbers below are made up. The method is what matters, because your tariff, your hours and your room decide the answer, not a general verdict.

What do your two summer bills tell you?

Pull out the electricity bills for the same months of the last two summers, plus one cool month. Write down the units consumed for each. The cool month is your baseline, because it shows what the house uses without cooling.

Say the baseline month is 180 units and last May was 420 units. The extra 240 units are roughly the cooling load of whatever you used then, such as a fan, cooler or an old AC. If you were running an AC for about 8 hours a day, 30 days, that is 240 hours, so the old setup used about 1 unit per hour of cooling.

How do you estimate units for each AC?

Each AC has a label that states its power input in watts or kilowatts. Use that figure, and then allow for the fact that the compressor does not run constantly. A duty factor of 60 per cent is a made-up planning figure; your room and the set temperature change it.

  1. Units per hour = power input in kW x duty factor
  2. Units per month = units per hour x hours per day x days
  3. Cost per month = units per month x rate per unit

Let us take two imaginary machines. The window AC lists 1.5 kW, the split lists 1.3 kW. Assume 8 hours a day for 30 days, a duty factor of 0.6 and a top-band rate of ₹8 a unit.

ItemWindow ACSplit AC
Power input1.5 kW1.3 kW
Units per hour (x 0.6)0.900.78
Hours per month240240
Units per month216187.2
Cost at ₹8 a unit₹1,728₹1,497.60

In this made-up case the monthly difference is about ₹230. If you run the AC for four months in a year, that is roughly ₹920 across the summer.

Does the purchase price change the answer?

Yes, so add it. Say the split costs ₹10,000 more to buy and install. Divide that by the yearly running saving: 10,000 / 920 is about 10.9 years. On these figures the saving alone would not justify the higher price. Change the hours to 12 a day, or the rate to ₹10, and the answer moves, which is exactly why you should use your numbers.

Running cost is also not the whole choice. Noise in a bedroom, whether the wall can take a window unit, what a landlord allows, space for an outdoor unit, and installation charges can matter as much as the electricity. List them next to the table.

What if you already own an AC and want to test the guess?

Check the next bill. If your guess was 216 units and the bill shows 190 extra units over baseline, adjust the duty factor down and use that corrected factor for any further comparison. A guess checked against a bill is far more useful than a number from a brochure.

How do you log the running cost?

Add a monthly line for electricity and note the units next to the amount. Over two summers you will see which months are heavy and can compare them with the estimate. If you track spending in an app or a sheet, keep electricity as its own category rather than hiding it inside household bills, so a rise in summer is visible.

  • Units this month and last year's same month
  • Hours of AC use, even a rough count
  • Rate band reached
  • Bill amount and due date
SPENDIXAI JOURNAL

Useful ideas start with a clearer picture of your own spending.

Explore your reports